Distributors of Quality Hardwoods & Building Products

-

Home

Company

Products

Locations

Technical

Contact

Login

 

Forest and Lumber  |  Millwork and Moulding  |  Plywood  |  Veneer  |  Other

Technical

Forest & Lumber

Millwork & Moulding

Plywood

ANSI Plywood Grades

Page 1

Page 2

Page 3

Page 4

Page 5

Page 6

Page 7

Page 8

Veneer

Other

 

Technical Section

(Page 5 of 8)

 

ANSI Plywood Grades

 
Pecan and Hickory

Summary of Hardwood Face Grade Characteristics

Cut

Plain-Sliced (Flat-Cut), Quarter-Cut, Rotary Cut

Grade Description

A B

Color and Matching

Sapwood

Yes Yes

Heartwood

Yes Yes

Color Streaks or Spots

Yes Yes

Color Variation

Yes Yes

Sharp Color Contrasts at Joints

No No

Type of Matching

Book Matched

Slip Matched

Pleasing Matched

 

Yes
Specify
--

 

Specify
Specify
Yes

Nominal Minimum

Plain-S.

Width of Face

Quarter

Components

Rotary
5 in.
3 in.
--
3 in.
4 in.
--

Natural Characteristics

Small Conspicuous Burls & Pin Knots - Combined Avg. Number

2 per 1 sq ft
64 per 4 ft x 8 ft panel
No Limit

Conspicuous Burls - Max. Size

3/8 in. 1/2 in.

Conspicuous Pin Knots

Avg. Number

Max. Size: Dark Part

Total

2 per 1 sq ft

64 per 4 ft x 8 ft panel
1/8 in.
1/4 in.

 

No Limit
1/8 in.
1/4 in.

Scattered Sound and Repaired Knots - Combined Avg. Number

Max Size - Sound

Max Size - Repaired

Avg. No. - Repaired

No
1 per 8 sq ft

4 per 4 ft x 8 ft panel

3/8 in.
1/8 in.
1 per 8 sq ft

Mineral Streaks

Slight Yes

Bark Pockets

Slight, Occasional Few to 1/4 in. x 2 in.

Worm Tracks

Slight Few

Vine Marks

Occasional Yes

Cross Bars

Occasional Yes

Manufacturing Characteristics

Rough Cut / Ruptured Grain

No Slight

Blended Repaired Tapering Hairline Splits

Two
1/16 in. x 6 in.
Four
1/8 in. x 8 in.

Repairs

Small Blending Blending

Special Characteristics

Bird Peck

Slight Yes

Knife Marks

Knife marks may occur in these high density species.

All wormholes, open splits, open joints and open bark pockets must be filled.  Doze is not allowed.

Outside components will be a different size to allow for edge trim loss and certain types of matching. 

For Pecan and Hickory, conspicuous pin knots means sound knots 1/4 inch or less in diameter with dark centers larger than 1/16 inch.  Blending pin knots are sound knots 1/4 inch or less in diameter with dark centers 1/16 inch or less and are allowed in all grades of Pecan and Hickory. 

To achieve a more rustic appearance, bird peck shall be specified.

The AA, C, D and E grades are available as a custom order.

ANSI/HPVA HP-1-2000
 

© 2005 Hogan Hardwoods & Mouldings. All rights reserved  | 1-800-255-5460